Control Axes:
1. Control axes: 5 axes (X, Z, Y, 4th and 5th)

2. Interpolation axes: X, Y, Z, 4th and 5th  linear interpolation; X,Y and Z three axes linear and spiral interpolation, any two axes arc interpolation;

3. PLC control axes: 5 axes

Feeding axis function:

1. Minimum command unit: 0.001mm or 0.0001mm can be selected

2. Position command range: ±99999999 × minimum command unit

3. Rapid traverse speed: When the command unit is 0.001mm, the maximum speed is 60m/min; (0.0001mm,  the maximum speed is 24m/min)

4. Rapid override: F0, 25%, 50% and 100%, total four levels, real-time adjustment;

5. Feeding override: total 16 levels: 0~150%, real-time adjustment;

6. Interpolation mode: linear, arc and spiral interpolation and rigid tapping

7. Auto chamfering

Acceleration and deceleration function:

1. Cutting feeding: Acceleration or deceleration in linear type/index type or front/rear is selectable.

2. Rapid traverse: Acceleration or deceleration in linear type/index type or front/rear is selectable.

3. Tapping: Acceleration or deceleration in linear type/index type or front/rear is selectable.

4. The starting speed, finishing speed and time of acceleration and deceleration are set by the parameter.

Spindle function:

1. Analog voltage 0V~10V output in two channels, support two-spindle control

2. Spindle encoder feed back in one channel, the resolution of spindle encoder can be set (0 or 100p/r~5000p/r)

3. Transmission ratio between encoder and spindle is:(1~255):(1~255)

4. Spindle speed: It is specified by S code or PLC signal, the speed range is 0rpm~9999rpm.

5. Spindle override: total 8 levels: 50%~120%, real-time adjustment

6. Spindle constant surface speed control

7. Tapping cycle/rigid tapping

Tool function:

1. Tool length compensation

2. Tool radius compensation (C type)

3. Tool wearing compensation

4. Tool life management

Precision compensation:

1. Backlash compensation

2. Pitch error compensation in memory type

PLC function:

1. PLC program in two levels, maximum 5,000 steps, the refresh cycle of the 1st level program: 8ms.

2. PLC program communication download

3. Support PLC warning and PLC alarm

4. Support many PLC programs (maximum 16), the current running PLC program can be selected

5. Basic I/O: input in 40 points/output in 32 points